|
|
Polaris Ranger XP HD EV RZR RZRS RZR4 Crew, Yamaha Rhino, Kawasaki Mule Teryx, Arctic Cat Prowler
|
|
|
|
|
|
|
|
|
This Turn Signal Switch will fit all years for the Polaris Ranger XP / HD / EV / TM / 400 / 425 / 500 / 700 / 800 / RZR / RZRS / RZR4 and Crew, all years for the Yamaha Rhino, all years for the Kawasaki Teryx & Mule, and all years for the Arctic Cat Prowler. (SEE NOTES BELOW) This kit can be easily installed on any Side-by-Side (side x side), UTV, Golf Cart, Club Car, Sand Car, Dune Buggy, etc.
|
|
Note: the 2009-2011 Polaris Ranger XP / HD and the 2010-2011 Ranger 800 Crew use our custom turn signal switch (TSS) mounting strap. This custom strap will allow the tilt steering to have full range of motion with the turn signal switch mounted just under the steering wheel. Order from the drop down box (BELOW) b) TurnSignal Switch: 09-11 Ranger XP/HD (TSS) Strap or 10-11 Ranger 800 Crew (TSS) Strap.
Note: the 2010-2011 Polaris Ranger EV & 400 use our custom turn signal switch (TSS) mounting plate. This custom plate was designed to mount the turn signal switch below the steering wheel on the plastic shroud. Order from the drop down box (BELOW) b) TurnSignal Switch: 10-11 Ranger EV/400 (TSS) Plate. This custom (TSS) mounting plate is only available on the LED turn signal kits.
Note: the 2008-2011 Arctic Cat Prowler with tilt steering, you may want to use a 5" inch hose clamp to mount the turn signal switch.
Note: the 2010-2011 Kawasaki Teryx with the plastic shroud molded up to the steering wheel, you will need to cut some of the plastic to make room for mounting the turn signal switch OR use a 5" inch hose clamp around the plastic shroud.
|
|
|
|
|
|
|
|
|
In Stock & Ready to Ship!
|
|
|
|
This is a 6, 12 or 24 volt Turn Signal Switch, which has a pilot light for the turn signals and 4-way emergency flashers (hazard warning). The turn signal switch has a pull on flare tab for the 4-way hazard lights, an added 18" ground wire (for better grounding of the turn signal switch) and the hardware to mount it to your steering column.
This Turn Signal Switch can be easily installed and comes with the wiring diagram and instructions. Each wire has a different color and the wiring diagram shows where each colored wire goes. I include my phone number and e-mail address with the instructions, so if you have any questions about your installation you can contact me.
With this turn signal switch you can supply whatever lights, flasher, in-line fuse holder and fuse, color wire and connectors you want to use. My customers have installed this turn signal switch on the Polaris Ranger 400 / 425 / 500 / 700 / 800 / TM, EV, XP, HD, RZR, RZRS, RZR4 and Crew, the Yamaha Rhino, the Kawasaki Mule & Teryx, and the Arctic Cat Prowler.
This Turn Signal Switch can be easily installed on any 12 volt Side-by-Side (side x side), UTV, Golf Cart, Club Car, Sand Car, Dune Buggy, etc. This turn signal switch has been installed on thousands of units, very nice and easy to operate.
The Motor Vehicle Department and your local police departments will be impressed. Everyone who rides on the street, off road, at the dunes or in congested riding areas, should have turn signals for there added safety.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
In Stock & Ready to Ship!
|
|
|
|
|
|
 
|
|
|
|
Not what your looking for, checkout these kits:
|
|
|
|
|
For more information:
EZ Turn Signal Kits
P. O. Box 1818
Glendale, AZ 85311-1818 US
E-mail: Cisco@LEDTSK.com
Phone: (623) 435-1337
Phone: (928) 369-2892
|
|
|
|
|
|
|
|
|
